Serving Clarksville, Middle Tennessee and the Nashville area · based in Woodlawn, TN
Free Estimates (931) 572-8673
Wilson Forestry & Excavating logo
Our Services

Erosion Control in Woodlawn, TN

Erosion Control · Woodlawn, TN

Keeping soil in place when the rain comes hard

Erosion control keeps soil on your site instead of in the ditch, the creek, or the road below. We are based in Woodlawn, just west of Clarksville, and we work across Montgomery County and out toward Nashville. Wilson Forestry and Excavating is an approved erosion control contractor with TDEC and has done TDEC jobs. Call or text (931) 572-8673 for a free estimate.

Most calls come in for the same few reasons. Rain is cutting a slope, a ditch is silting in, or bare dirt is running onto a road. We set the measures that fit the ground and the grade. This work often runs alongside site prep and grading or fresh land clearing, since open ground washes first.

What We Handle

  • Silt fence set along the low side of a site to catch sediment
  • Rock check dams in ditches to slow water before it cuts
  • Stabilized construction entrances so mud stays off the public road
  • Riprap at pipe outlets where fast water hits bare dirt
  • Diversions and slope shaping so runoff leaves at a safe speed
  • Seeding and matting to hold bare ground after the dirt work
  • Ditch cleanout and reshaping on farm roads and access roads
  • Measures checked and repaired while the job is still running

Free Erosion Control Quote

Tell us about the job and the ground. We will get right back to you.

Erosion Control Services on Roads and Slopes

A road washes when water runs down it instead of off it. The fix starts with the shape of the ground. We cut ditches that drain and set the crown so water sheds off the side.

Rock check dams go in the ditch to slow water before it can cut. Riprap goes at pipe outlets, where water leaves fast and lands on bare dirt. On gravel driveways and access roads, that shaping does much of the erosion control work.

Slopes get read the same way. We look at where the water comes from and how far it runs before it hits anything. Then we break that run up with a diversion or a line of rock. Matting and seed hold the face until it takes.

Why Ground Washes Out in Middle Tennessee

Middle Tennessee gets close to 50 inches of rain a year. A lot of it arrives in hard bursts instead of a steady soak. The ground here is clay sitting over limestone, and in places the rock is close to the surface.

Clay does not take water in quickly. Most of a heavy rain runs across the top instead of soaking down. On a wooded lot that runoff moves slowly, because roots and leaf litter hold it back. Strip that cover for a build and the same rain can cut a rut in an afternoon.

The land around Woodlawn rolls, with creek bottoms between the ridges. Clarksville sits where the Red River meets the Cumberland. Water off a new subdivision or a hillside pasture ends up in those creeks. It carries whatever soil it picked up on the way.

Erosion Control Contractors and Tennessee Stormwater Rules

In Tennessee, construction that disturbs about an acre or more generally needs stormwater permit coverage from the state. Smaller lots can count when they are part of a larger development. Thresholds and paperwork change, so confirm the current rules with TDEC before a job starts.

Clarksville and Montgomery County also run their own stormwater programs. Local requirements can be tighter than the state minimum. Builders usually have a plan drawn that says which measures go where. We install what the plan calls for and keep it working while the job runs.

Farms and homeowners call for the same reasons at a smaller size. A farm road cuts deeper every spring, or a bank behind the house keeps giving way. When the trouble is standing water rather than moving water, that is yard drainage and French drains work. Either way, call or text (931) 572-8673 and we will come out and give you a free estimate.

Open excavation cut into red clay on a job site Graded dirt on a cleared lot with the tree line behind it

Ready to get started?

Free, no-obligation estimates across Clarksville, Middle Tennessee and the Nashville area.

(931) 572-8673
How We Work

How a Job With Wilson Forestry and Excavating Runs

From the first call or text to the finished property, here is how it goes.

1

Call or Text Us

Call or text (931) 572-8673 with what you need done and where the property sits. Photos and rough acreage help us size the job before we drive out.

2

Site Visit and Free Estimate

We come out and look at the ground, the access, and where the water runs. Then we put a price on the work and go over it with you. The visit and the estimate are free.

3

Pick a Start Date

Once you approve the estimate, we get you on the schedule. Weather and ground conditions set which week works, and we tell you where you stand.

4

The Work Gets Done

Equipment comes in and the job runs in order, from clearing to digging to final grade. We keep the site drained and passable while we work.

5

Final Walkthrough

We go over the finished job with you before the equipment leaves. Anything that needs another pass gets handled while we are still on site.

FAQ

Erosion Control Questions, Answered

Common questions about erosion control across Clarksville, Middle Tennessee and the Nashville area. If yours is not here, call or text and ask.

Call (931) 572-8673

Do I need a permit for erosion control on my project?
It depends on how much ground you are disturbing. In Tennessee, construction that disturbs about an acre or more generally needs stormwater permit coverage from the state. Smaller lots can count when they are part of a larger development. Check the current rules with TDEC or your local stormwater office before you start.
What does erosion control work actually involve?
It is a set of measures matched to the site. Silt fence catches sediment at the low edge of the work. Rock check dams slow water in a ditch, and riprap takes the hit where a pipe lets out. Seeding and matting hold the bare ground once the dirt work is finished.
Is Wilson Forestry and Excavating on TDEC's approved contractor list?
Yes. Wilson Forestry and Excavating is an approved erosion control contractor with TDEC, and we have done TDEC jobs. That is the credential we hold for this line of work. If your builder or engineer needs it noted on the paperwork, ask us when you call.
When should erosion control go in on a job site?
Before the ground opens up. Measures like silt fence and a stabilized entrance belong at the start of a job. If a slope has already cut, we can still fix it, though there is more dirt work to redo. Getting it in early is usually the cheaper way through.
Do you do erosion control for builders and general contractors?
Yes. Builders and general contractors bring a good share of our work, from house lots to commercial sites. Usually there is already an erosion plan drawn, and we install what it shows. We keep those measures working while the job runs.
How far do you travel for erosion control work?
Clarksville and Montgomery County are home ground, and we are based in Woodlawn just west of the city. From there we cover roughly 60 miles, west to Dover and Cumberland City and south toward Nashville. We travel to Dickson, Springfield, Ashland City, and Franklin as well. See the towns we cover or call or text (931) 572-8673.
More From Wilson Forestry & Excavating

Work That Pairs With Erosion Control

Deep utility trench in red clay with a grade rod set for depth

French Drains

Water standing in the yard or against the house needs a way out. We regrade the ground and put in French drains and pipe that carry it off.

Learn More
New access road cut through the woods, red clay base graded smooth

Gravel Driveways and Roads

We build new gravel driveways, farm roads and access roads across Montgomery County and out toward Nashville. The road bed gets cut and stoned, then crowned so water sheds off instead of standing in the tracks.

Learn More
Lot graded to bare dirt after site prep, trees kept at the edges

Site Prep and Grading

We handle the dirt work before a build: building pads, cut and fill, rough and finish grading, and driveway cuts. The ground ends up level where it should be and sloped so water leaves the site.

Learn More
Why Choose Wilson Forestry & Excavating

Clearing the way for your next big project

On TDEC's Approved Contractor List

We are on TDEC's approved contractor list for erosion control, and we have done those jobs. That counts on sites where slopes, ditches, and roadways have to hold through a Tennessee rain.

Builders Send Us Repeat Work

Much of our work comes from builders and general contractors, on house builds and commercial buildings. The same names call us back for the next site.

Roots in Road Building

The company started out cutting roads for a timber company's trucks and equipment. Farm roads, construction entrances, haul roads, and timber roads are still a big part of what we build.

Free Estimates Across the Area

Estimates are free, and we come out to the site to give you one. We cover Clarksville and Montgomery County out to Dover, Springfield, Dickson, Nashville, and Franklin.

Guides and Resources

Erosion Control Guides

Free Estimates

Get In Touch With Wilson Forestry & Excavating

Tell us what the job is and where the property sits, and we will get you an estimate. You can also call or text (931) 572-8673 if that is faster.

  • (931) 572-8673 · call or text
  • Woodlawn, TN · serving Clarksville, Middle Tennessee and the Nashville area
  • Free estimates · TDEC approved erosion control contractor

Get a Free Quote

Tell us about the job and the ground. We will get right back to you.